Step 1:
Remove cartridge from
printer. Remove the identification label from the top of the cartridge.
Step 2:
Assemble the syringe and
needle, pierce the bottle seal and fill with the correct ink colour. I
recommend filling these cartridges with a maximum of 5ml of ink due to the fact
that the majority of them are physically restricted on the inside.
STEP 3:
Insert the needle into the appropriate fill hole and push
down into the cartridge slowly. Ensure you are filling the correct chamber with
the correct colour ink. When the ink appears the filling hole, pull back the
syringe plunger slightly to remove the excess ink. Blot the printhead with
absorbent material until it stops dripping before moving onto the next colour.
Step 4:
Finishing all colours apply label or tape. Ensure the
printhead has stopped dripping before returning the cartridge to the printer.
Operate the printers cleaning cycle 1 to 3 times. Clean the syringe and needle
thoroughly with water for future use.
No comments:
Post a Comment